Bioquell WIC-1, Руководство пользователя

Страница: 31 / 38

USER MANUAL
TD064-O&M-001
REVISION 4
Page 31 of 38
Alarm
No.
Alarm Message Condition Action User Action
74 HMI A
COMMUNICATION
TIMEOUT
Communications between the
chamber and Door A HMI has been
interrupted.
If in cycle goes to
OFF mode.
Contact Service
Provider.
75 HMI B
COMMUNICATION
TIMEOUT
Communications between the
chamber and Door B HMI has been
interrupted.
If in cycle goes to
OFF mode.
Contact Service
Provider.
76 HVAC DAMPER
OPENING FAULT
HVAC OPTION 1 enabled. If time
expired and signal not received.
If in cycle goes to
OFF mode.
Investigate BMS system
and its signals. If OK
contact BMS supplier.
77 HVAC DAMPER
CLOSING FAULT
HVAC OPTION 1 enabled. If time
expired and signal not received.
If in cycle goes to
OFF mode.
Investigate BMS system
and its signals. If OK
contact BMS supplier.
78 BMS FAULT HVAC OPTION 1 disabled. If time
expired and signal not received.
If in cycle goes to
OFF mode.
Investigate BMS system
and its signals. If OK
contact BMS supplier.
7.2 Fault Finding
Fault/Problem Site Checks Further Action
Door is difficult to open Check for damage to door
and seal Contact Bioquell Service
Provider
An alarm is displayed Refer to Section 7.1 and
perform checks
suggested Contact Bioquell Service
Provider
H
2
O
2
is detected outside
the chamber
Check the door seals are
not leaking Contact Bioquell Service
Provider
HPV Generator will not
run a cycle Check the connection of
the control cable between
the Generator and
Chamber Contact Bioquell Service
Provider
Incorrect Password Re-enter password in
accordance with User
Manual
Re-set password by
administrator
Contact person with
administration rights
Contact Bioquell Service
Provider