24
Picture 17 – Fan Power Change Window (flame start-up)
To change parameter value, it is required to press the encoder button, the value
will change symbols color to red. By turning encoder set up the needed value and
confirm the entered value by pressing the button.
Value limits:
1 – 99%.
!ATTENTION!
It is not recommended to set up fan power while flame start-up lower than MIN fan
power set up in item 3.3.3. This may result in lack of air supply during flame start-
up.
To leave the fan adjustment window move the cursor – frame to icon «Back»,
, and press the encoder button, the Controller will go back to flame start-up menu.
4.2.2 Flame Start-Up Completion
To enter the change window (Picture 18) it is required to select menu item
«Flame Start-up Completion»,
, in the flame start-up menu by turning encoder, and
press the button. The current parameter value will be displayed in the popped up
window.
Parameter value change is similar to item 3.3.1.
Содержание MPT-AIR BIO PID
Страница 1: ...OPERATION MANUAL FOR AIR BIO PID ELECTRONIC CONTROL UNIT FOR SOLID FUEL BOILER...
Страница 37: ...37 For Notes...
