Bionet Cardio7, Руководство по эксплуатации

Страница: 60 / 171

V 1.31
2021. 05 60 / 171 Doc. # : BN-OP-C7
9) Printing Form
In this section, descriptions and samples of various printing forms are provided.
◼
Rhythm Printing Form
- 3CH printing: To print 3 channels at the same time (I ~ III / aVR ~ aVF / V1 ~ V3 /
V4 ~ V6)
- 6CH printing: To print 6 channels at the same time (I ~ aVF / V1 ~ V6)
- 12CH printing: To print 12 channels at the same time (I ~ V6)
◼
Record Printing Form
- ‘3CH+1’: I, II and III will be recorded for the first 2.5 seconds, aVR, aVL and aVF
for the next 2.5 seconds, V1, V2, V3 for the next 2.5 seconds and V4, V5, V6 for
the next 2.5 seconds. And 1 channel of rhythm will be recorded for 10 seconds
at the bottom.
- ‘6CH+1’: I, II, III, aVR, aVL and aVF will be recorded for the first 5 seconds and
V1, V2, V3, V4, V5 and V6 for the next 5 seconds. And 1 channel of rhythm will
be recorded for 10 seconds at the bottom.
- ‘12CH’: 12 -channel rhythm will be recorded as I, II, III, aVR, aVL, aVF, V1, V2, V3,
V4, V5 and V6 at the same time for 10 seconds.
- ‘3CH+3’: I, II and III will be recorded for the first 2.5 seconds, aVR, aVL and aVF
for the next 2.5 seconds, V1, V2, V3 for the next 2.5 seconds and V4, V5, V6 for
the next 2.5 seconds. And 3 channels of rhythm will be recorded for 10 seconds
at the bottom.
- 6CH+1(ST): I, II, III, aVR, aVL and aVF will be recorded for the first 4 seconds and
V1, V2, V3, V4, V5 and V6 for the next 4 seconds. And 1 channel of rhythm will
be recorded for 10 seconds at the bottom. The amplitude of the measured ST
wave is printed as an ST map. It is printed at 25mm/sec regardless of output speed
◼
Form of Beat Report Output
-
Choose an additional output form after printing out diagnosis: either Text, Guide or
Vector.
-
Text: to output representative beat and each diagnostic parameter. Output will come
at 50mm/sec if the output speed is set at
‘5, 12.5 and 25 mm/sec’, whereas it will come
at 100 m/sec if set at ‘50 and 100mm/sec’.
-
Guide: to output representative beat and each diagnostic parameter, with diagnostic
guide for arrhythmia. Output will come at 50 mm/sec regardless of the output speed.
-
Vector: to output representative beat and each diagnostic parameter and Vector of
QRS, as indicated by the arrow. Output will come at 50 mm/sec regardless of the
output speed.
- -ST Map (Dot): Prints the representative bit and each diagnostic parameter and
displays the amplitude of the ST wave as a point and a linear ST Map. It is printed at
50mm/sec regardless of output speed.
-
ST Map (Bar): Prints the representative bit and each diagnostic parameter and displays
the amplitude of the ST wave as a bar ST Map. It is printed at 50mm/sec regardless of
output speed