www.biomark.com +1 208.275.0011
Overview
The Biomark
Submersible Battery
is shipped unassembled. This document covers the
assembly of the
72 Ah
(2-week runtime)
or 180 Ah
(4-week runtime) submersible battery pack.
Please follow these procedures to successfully install and seal your submersible battery pack.
Failure to follow manufacturer guidelines and specifications may void Biomark’s manufacturer’s
warranty.
Shipment includes:
•
(1) Submersible battery enclosure
•
(1) Submersible battery enclosure entry plate with Battery Management System (BMS) &
Wiring
•
(1) Sealing Gasket
•
(2) Foam inserts
•
(40) Stainless Steel ¼-20 x 2.5” partially threaded hex head screw – 7/16” hex size
•
(80) Stainless Steel .281” ID .625” OD – standard ¼” flat washers used
•
(80) Stainless Steel Nylon-Insert Locknut, 1/4"-20 Thread Size- 7/16” hex size
•
Bus Bar Kit
o
Each kit will include (2) Vertical and (1) Horizontal bus bars with the following
battery terminal hardware:
o
72Ah Battery Terminal Hardware
(8) M6 - 1 x 12mm full thread hex head screw– 10mm hex size
QUICK START GUIDE
SUBMERSIBLE BATTERY
ASSEMBLY & INSTALLATION
