BIOENNO POWER SOLAR SYSTEM GUIDE
PROCEDURE AND OVERVIEW FOR PORTABLE SOLAR SYSTEMS FOR OFF GRID APPLICATIONS
PART 1: Battery Type
Battery Type 1:
Small Capacity PVC Wrap, has connectors attached, includes a 2.1x5.5mm Coaxial Plug for charging, PP45 Powerpoles for
discharging, covers models from 3Ah-20Ah, attach your Solar Charge Controller to the Coaxial Plug and Load to the Powerpoles
Battery Type 2:
ABS Sealed Hard Case, has either F2 Connectors or Screw Terminals, discharging and
charging are done by the same terminal tab/post, covers models 3Ah – 300Ah, run two sets of cables from
the terminals, one to the Solar Charge Controller and the other to your Load
Battery Type 3:
Large Capacity PVC Wrap, has connectors
attached, includes pp45 Powerpoles for Charging, SB50
Powerpoles for discharging, covers models 30Ah+, attach your
Solar Charge Controller to the PP45 Powerpoles and Load to
the SB50 Powerpoles*
*
BLF-1260L uses a pair of SB120 Powerpoles in the same setup
PART 2: Solar Charge Controller
Solar Panel:
Use the Solar Panel Terminals on the far left
, use a Phillips Head Screwdriver to unscrew the terminals, take desired cable, strip off
silicone sheathing to desired length, insert bare wire end into the terminals, tighten the terminals but do not over torque*
Battery:
Use the Battery Terminals in the middle
, use a Phillips Head Screwdriver to unscrew the terminals, take desired cable, strip off silicone
sheathing to desired length, insert bare wire end into the terminals, tighten the terminals but do not over torque
Load:
Attach directly to battery; do not use the Load Terminals on the far right
*Bioenno Power does not require a specific make, model or type of Solar Panel, but before attaching, please confirm that your Solar Panel is
appropriately sized for your Battery and for your Load!
BIOENNO POWER SOLAR SYSTEM GUIDE
PROCEDURE AND OVERVIEW FOR PORTABLE SOLAR SYSTEMS FOR OFF GRID APPLICATIONS