Biocare PM-900, Руководство пользователя, Страница: 38 / 182

Chapter 3 Basic Operation
--26-- User Manual of Veterinary Monitor

Whether the lead cable, cable, sensor or external add-in equipment has been well connected to the module.

Whether there is the prompt that the associated parameter has not been turned on in the prompt region at the
bottom of the screen. If there is such a prompt, please enter [Screen Setup] for the associated parameter and
waveform setup.
Attention

The most waveform of Standard Screen Layout Setup for monitor is eight.
3.7 Main Menu
Select the Main Menu Shortcut key on the screen, or press the Main Menu pushbutton on the monitor to
open the main menu, as shown in Figure 3.4:
Figure 3.4 Main Menu
Most operations and setup of the monitor can be accomplished by operating in this menu.
3.8 General Setup
3.8.1 Monitor Definition
Select [Main Menu] – [Maintenance] – [User Maintain>>], and input the user maintenance password to set-up the
monitor. Set up the hospital information, unit, time, alarm, network, default administration, CO
2
module
maintenance and other information. Please refer to User Maintain in section 14.6 for detailed explanation.
3.8.2 Screen Type Setup
Select [Main Menu] – [System] – [Screen Setup], or press directly to enter the screen setup. Select [Interface
Type]: Standard, Minitrends, BigNumerics, OxyCRG, View Other Bed, 7 lead half and 7 lead full. Please refer to
User Interface in Chapter 5 for detailed information.