Biocare PM-900, Руководство пользователя, Страница: 35 / 182

Chapter 3 Basic Operation
User Manual of Veterinary Monitor --23--
3.2.2 Turn On
After the power source is switched on, after system self-examination the monitor enters the original monitoring
interface. Then, the user can perform operations.

Check all monitoring functions to be sure that they are normal.

If batteries are equipped, charge the batteries after each time of use to insure that it has sufficient electric
charge.
Attention

If the monitor displays evidence of damage or an error prompt, stop using the monitor for veterinary
monitoring. Please contact the vendor or the company.

The interval between restarts should be more than 1 minute. Or, abnormal operation may be
caused.
3.2.3 Sensor Connection
Connect the needed sensor to the monitor and the monitored body part of the animal.
Please refer to the associated sections in Chapter IV for more detailed information on sensor connection methods
and requirements.
3.2.4 Recorder Checking
If this series of monitors have an internal recorder on the right side, check whether there is paper in the outlet.
Please refer to Chapter 10 for recording information.
3.3 Monitoring
1. Decide what functions should be monitored or measured.
2. Install the required modules, animal cables and sensors.
3. Check whether the animal cables and sensors are the correct ones or not.
4. Check whether the monitor has been accurately set up.
5. Please refer to corresponding chapters and sections for various function measurements and monitoring.
3.4 Turn Off
Please shut down the monitor by following the following procedures:
1. Make sure that the monitoring for the animal has completed.
2. Disconnect the cables and associated sensors connected to the animal.
3. Make sure that veterinary monitoring and care data have been stored.
4. Press the power switch to turn off the monitor (shutdown time lag depends upon the preset by the
manufacturer).