BINZEL-ABICOR BRS-CC, Руководство по эксплуатации

Страница: 33 / 84

BRS-CC 5 Putting into operation
EN - 12
5.6 Setting up the clamping position

See also Fig. 5 Putting into operation on page EN-10
1
Move the torch with the gas nozzle
(1)
vertically to the tool axis (milling cutter axis) over the
BRS-CC (3)
(P1).
2
Approach the clamping position (P2). Make sure that the cylindrical part of the gas nozzle
(1)
lies evenly
against the prism
(2)
.
5.7 Setting up the compressed-air motor

See also Fig. 5 Putting into operation on page EN-10
1
Loosen the compressed-air motor from the guide block
(4)
by removing the screws
(3)
.
2
Pull back the compressed-air motor
(5)
in its fastener.
3
Place the required distance sleeve
(7)
on the milling cutter
(6)
.
4
Move the torch with the gas nozzle
(2)
to the clamping position (P2).
5
Keep the guide block
(4)
in the lower position (lift down).
6
Place the compressed-air motor
(5)
against the gas nozzle
(2)
with the distance sleeve placed
on top
(7)
.
1 Gas nozzle 2 Prism 3 Maintenance unit BRS-CC
Fig. 8
Setting up the clamping position
1 2
3
1 Clamping device
2
Gas nozzle
3 Screws
4
Guide block
5 Compressed-air motor
6
Milling cutter
7 Distance sleeve
Fig. 9
Setting up the compressed-air motor
1 2
3
4 5
6
7