BINZEL-ABICOR 881.3112, Руководство по эксплуатации

Страница: 35 / 108

M-Drive 5 Functional description
EN - 9
5 Functional description
The M-Drive is adapted electronically and mechanically to the master feeder system. All required valves and
connections have been installed in the housing.
6 Putting into operation
6.1 Installation
The M-Drive
can be attached both horizontally and vertically (e.g. directly above the wire drum).
The add-on consoles are not included in the scope of delivery and must be attached at the place of
installation. The appropriate mounting holes can be found in:

Fig. 1 on page EN-6
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing,
disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Close the gas supply.
• Disconnect the mains plug.
DANGER
Risk of injury
Safety switches on covers and protective devices are ineffective in manual mode.
• Greater concentration.
WARNING
Risk of crushing
Limbs can be drawn in and crushed.
• Do not reach into moving wheels.
NOTICE
• Please take note of the following instructions:

2 Safety on page EN-4
• The system may only be installed and put into operation by authorized personnel (in Germany see
TRBS 1203).
NOTICE
• Ensure clear access to the control elements and connections.
• Select a location that allows a short and rectilinear wire feed.
• Protect the components against rain and direct sunlight.
• Prevent dust and other foreign substances from entering the system’s cooling air stream.
• Only use the device in dry, clean and well-ventilated rooms.