BinTec BinGO Plus, Начало работы

Страница: 28 / 34

B
IN
GO! P
LUS
/P
ROFESSIONAL
22
Setting up the ISDN Interface
Select [ CM-1BRI, ISDN S0 ] to configure your ISDN inter-
face.
Depending on which protocol your ISDN subscriber in-
terface uses and whether or not the ISDN autoconfigura-
tion was successful, the [
CM-1BRI, ISDN S0 ] menu may
be displayed as follows:
The ISDN autoconfiguration procedure runs until ei-
ther the proper protocol is detected or the switch type is
set manually. If the cables are connected and auto detec-
tion just keeps running, you may have to select the appro-
priate ISDN protocol manually by scrolling through the
entries in the
ISDN Switch Type field using the spacebar or
the left and right arrow keys.
Leaving the Switch Type setting to “autodetect on
bootup” usually allows the BinGO! to automatically de-
tect the proper ISDN protocol each time the system boots.
To ensure data transfers are possible over ISDN, verify
that the autoconfiguration is correct or set your ISDN
switch type appropriately.
BinGO! Plus/Pro Setup Tool BinTec Communications AG
[WAN]: WAN Interface mybingo
Result of autoconfiguration: Euro ISDN, point to multipoint
ISDN Switch Type autodetect on bootup
Country Code 49
Area Code 911
Subscriber Number 1234
Advanced Settings >
SAVE CANCEL
Use <Space> to select
!