BinTec BIANCA/BRICK-XM, Начало работы

Страница: 14 / 36

BIANCA/BRICK-XM
8
Configuration
Configuring your new BRICK involves three simple steps
which are described in the following sections.
Gathering
the Information
(p. 10) 1. First, you will need to know several pieces of infor-
mation about your network setup. At a minimum
you will need to know the information listed in the
table shown on the following page. Fill in the fields
now and refer to them later when needed.
Accessing
the
BRICK
(p.11)
2. Next, you need to decide whether you want to con-
figure your BRICK over its Ethernet, TokenRing,
ISDN, or serial port. The section Accessing the
BRICK describes the possible ways of gaining ac-
cess to your new BRICK.
No matter which method you select, you will arrive
at an SNMP shell login prompt and can continue
with the configuration using the Setup Tool.
Configuration
with Setup Tool
(p.14) 3. The last step involves logging into the BRICK as
admin, using the bintec password, and issuing
setup at the shell prompt. Using the Setup Tool is
the easiest way to get your BRICK up and running.
After logging into the BRICK, use the information
you gathered for your local setup, and proceed to
the section Configuration with Setup Tool.