bintec elmeg RM7000, Руководство по установке

Страница: 21 / 33

3.8 Optional storage
The applications running in the second core of the device processor increase the features of the RM7000.
To access said features, the device must have an internally-installed hard disk or an SD flash memory expansion.
Note
Please see the bintec website http://www.bintec-elmeg.com for a list of supported hard disks.
3.8.1 Procedure to install a hard disk
To correctly insert a hard disk, please carry out the following steps:
(1) Switch off the device and remove the data cables as described under section Disconnecting on page 12.
(2) Remove the device from the workplace and place it in a stable and safe location, where it can be easily ac-
cessed and handled.
(3) Unscrew the screws on the front panel to extract the tray for hard disk access.
Fig. 22:
Unscrewing the screws from the front panel tray
(4) Once unscrewed, pull out the tray from the front panel slot.
Fig. 23:
Extracting the tray from the front panel
(5) If the tray is attached, skip to the next step. Otherwise, once you have extracted the tray, place the hard disk in
the correct position. Then fix the hard disk using the appropriate 4 screws, taking care not to damage it during
the tightening process (red arrows).
bintec elmeg
3 Components and Power Supply
RM7000 17