Chapter 3 Components and power supply
This chapter describes the chassis and components of the bintec H2 Aut. The following topics are
covered:
• Components
• Assembly instructions
• Power supply
• RESET button
• Data connection
• SIM card installation
3.1 Components
3.1.1 Front panel
The following image shows the front panel of the device.
Fig. 2:
bintec H2 Aut
: Front panel
The following table describes the front panel components:
Table 1: Front panel components
Item
Description
A
Power connection. For further information on the power connection, please see
on page 9
B
USB. Slot for an external USB modem.
C
MOD1, MOD2. WWAN/WLAN antenna connectors.
Specifically, cellular1/x or wlan1/0 for MOD 1, and cellular2/x or wlan2/0 for MOD2.
Each slot is configured for a specific type of device and depends on the commercial config-
uration.
D
GPS antenna connector.
E
MOD3, MOD4. WWAN/WLAN antenna connectors.
Specifically, cellular3/x or wlan3/0 for MOD 3, and cellular4/x or wlan4/0 for MOD4.
Each slot is configured for a specific type of device and depends on the commercial config-
uration.
3 Components and power supply
bintec elmeg GmbH
4
bintec H2 Aut
