Binder vdl 115, Руководство по эксплуатации

Страница: 151 / 207

VDL (E3.1) 06/2020 Page 151/206
19. Week programs
The MB2 program controller permits programming week programs with real-time reference. It offers 5
week program places in total with up to 100 shift points for each week program.
Path:
Main menu > Programs> Week program
For each program section you can enter the moment in time, the temperature set-point, the pressure set-
point, and the switching states of the special controller functions.
Before starting the program, check the set-points entered in fixed value mode. After the end
of the program, the set-points will equilibrate to these values.
Solvents and forming vapors can ignite if the drying temperature is too high
DANGER
Fire and explosion hazard when exceeding the auto-ignition temperature of the sol-
vent
due to excess drying temperature.
Serious injury or death from burns and / or explosion pressure.

Make sure that only solvents with an auto-ignition temperature that is higher than
200 °C /
392 °F
may be entered into the chamber. Check the auto-ignition temperature
with the safety specifications of the solvent. In the case of solvent mixtures, use the au-
to-ignition temperature of the material with the lowest auto-ignition temperature.
19.1 Starting an existing week program
In Normal display press the
Program start
icon to access the “Program start” menu.
“Program start” menu.
•
In the field “Program type” select the setting “Week program”.
•
In the field “Program” select the desired program.
•
There are no further settings available in the “Program start” menu for week programs, as they are
needed only for time programs.
After completing the settings, press the
Confirm
icon to take over the entries and exit the menu. The
program starts running.
If instead you press the
Close
icon to exit the menu without taking over the entries, the program will not
start.