Binder 9020-0402, Перевод оригинального руководства по эксплуатации

Страница: 88 / 173

MK LIT (E5) 01/2021 page 88/172
17.1.1 Performance during program delay time
During the configured program delay time until program start, the controller equilibrates to the current set-
points of Fixed value operation mode. Modifications of these setpoints are effective. When the configured
moment for program start is reached, the program delay time ends and the program starts running.
17.2 Stopping a running time program
17.2.1 Pausing a running time program
Press the
Program pause icon to interrupt the program..
The program is paused. The program runtime stops running down, the time display flashes.
There are the following options:
Press the
Program start icon to continue the program
Press the
Cancelling icon to cancel the program
17.2.2 Cancelling a running time program
Press the
Program cancelling
icon to cancel the program.
A confirmation prompt is displayed. Press the Confirm icon to confirm that the program shall really be
cancelled.
After confirming the message, the controller changes to Fixed value operation mode. The temperature will
then equilibrate to the setpoints of Fixed value operation mode.
17.3 Performance after the end of the program
After the end of the program the message
“Device changes to fixed value operation
mode” appears on the screen.
Press the Confirm icon.
As long as the message has not been confirmed, the setpoint of the last program section remains effective.
Program the last section as desired. If e.g. heating and refrigeration shall turn off, activate operation line
“Idle mode” in the last program section.
After confirming the message the controller changes to Fixed value operation mode. The temperature will
then equilibrate to the setpoints of Fixed value operation mode.