KB (E3.1) 08/2012
page 37/84
If you press button
during program course, the entered set-points of the actually running program
section are shown one after the other for 5 sec. each:
Display 1 shows
e.g. 25.5
C
(actual temperature value)
Display 2 shows P01:S03 02:07:12
(actual program P01, actual section S03, and remaining time
of program section S03)
Press key
Display 1 shows
e.g. 15
C
(actual temperature set-point 1)
Display 2 shows SP1 TEMPERATURE
5 seconds
Display 1 shows
e.g. 0
C
(actual temperature set-point 2)
Display 2 shows SP2 TEMPERATURE
(no function during program operation)
5 seconds
Display 1 shows
e.g. 100
(actual fan speed setting)
Display 2 shows
SP FAN SPEED
5 seconds
Only with option zero-voltage relay outputs via operation lines (chap. 16.6):
Display 1 shows
e.g. 000
(actual operating contact setting)
Display 2 shows OPERATION LINE
After program rundown (and, if appropriate, of the program repeats) the controller returns to fixed value
operation showing Normal Display and adjusting to the temperature and fan speed values that have been
previously entered in the fixed value entry mode.
10. User level
In this menu the following parameters can be se (in brackets the corresponding abbreviated information
given in display 2):
•
Unit address
(Adress)
Setting of controller address (1 to 254) for operation with the communication software APT-COM™.
•
User code
(User-cod)
Modification of the user code setting (factory setting “0001”) for access to the user level and the
program editor.
Keep in mind any modification of the user code. Without a valid user code it is no longer
possible to access these levels.
•
Safety controller mode
(Saf.mode)
The set-point mode can be entered as ...
Limit:
Maximally permitted temperature as absolute value (example: temperature set-point 37 °C, limit
setting to 39 °C)
Offset:
Maximally permitted temperature exceeding of the actual set-point temperature (e.g. 2 °C).
This maximally permitted temperature automatically changes with every change of the temperature
set-point.
Содержание 9020-0112
Страница 5: ...KB E3 1 08 2012 page 5 84 Product registration...
Страница 85: ......
