Binder 9010-0073, Руководство по эксплуатации, Страница: 23 / 67

BD / ED / FD (E2) 01/2022 page 23/66
The display shows alternately “
SP
” and the previous
temperature set-point
(example: 60 °C):
3.
With the buttons enter a set-point value between 0 and 300.
The desired temperature set-point can be selected in a temperature range from 5 °C /
9
°F
above room temperature up to 100 °C /
212 °F
(BD) or 300 °C /
572 °F
(ED/FD).
4. Wait 2 seconds until the entered temperature value is taken over (display flashing once).
5. Press button to return to normal display / actual value display (automatically after approx. 30
seconds).
Adjust the safety device following any changes of the set-point (chap. 7).
6.3 Time functions: Continuous operation and Timer operation
Press the time management button .
The timer indicates its current time function. There are two possible time functions:
Continuous operation
The display shows alternately “ t1 ” (time function) and the time function “Continuous operation” “ t inf ”:
The heating and fan (with FD) are permanently active, independent of the timer setting.
Timer operation
The display shows alternately “
t1
” (time function) and the running-down
time
or “
tOff
”:
or
Remaining time (example: 28 Min.) – Timer running
down
Heating and fan (with FD) are active until the timer has run-
down.
Timer not programmed or run-down “t off”
If the timer has run-down, heating and fan (with FD) are
permanently off.
Press button to return to normal display (actual value display) (automatically after approx. 30
seconds).