BimmerTech BMW F10 Carplay MMI Prime, Инструкция по установке и эксплуатации

Страница: 20 / 41

Installation Instructions - BMW F10 CarPlay MMI Prime
Installing the Front View Camera (FVC)
Once again the F30 video installation guide will offer you invaluable information on front camera
installation process:
https://youtu.be/SksfQZnKILg?t=11m57s
Drop the plastic area shown below by removing the two 10mm nuts, as pictured below. Once the nuts
are removed, use a trim tool to gently pry down and pop the remaining clips. Run the wires under the
plastic by the foot well of the driver’s seat, being careful not to interfere with the airbag.
Remove the three 10mm plastic bolts. Turn these 90 degrees counter clockwise to release. Pull off
the plastic panel to expose the firewall and the grommet that we will be drilling through.
The simplest and most efficient way to route the Front View Camera wire through the firewall is to drill
a hole in the existing grommet, as shown below. Be sure to drill a large enough hole (yellow dot), so
that the plastic clip will easily fit through, while being extremely careful not to make contact with any
other wires.
Once you’ve drilled through the grommet, use a sturdy wire or a thin hanger to route the wire through
the grommet.
Please remember the battery must be disconnected – we don't want fans to turn on while you're
working with your hands under the hood.
BimmerTech FZE | Phone: +1(646) 439-7920 | www.bimmer-tech.net 20