BIMG Metvisa FTG.150B, Инструкция по эксплуатации

Страница: 21 / 44

21
4.3 Operating Procedures
Before operating the equipment, make the perfect cleaning, especially inside the oven.
Clean the equipment with the gas inlet valve of the oven and the gas valves of the closed cylinders
and the oven is at room temperature and disconnected from the mains. Follow the cleaning
instructions in item 5 of this manual (below).
After this initial care, make sure that the gas hose connections are properly secured and that
there are no leaks.
CAUTION!
For the first use of model equipment FTG.150B and FTG.300B (models with carbon steel
chamber with high temperature paint finish) it is necessary to cure the paint inside the oven
(chamber). To do this, the empty oven must be switched on and the temperature raised to
200°C for a minimum of 60 minutes. Follow the operating instructions in the following
operation item.
During the curing process of the paint, odor and smoke will be released due to the burning of the
paint.
Turn off the machine and wait until the oven is at room temperature. A FTG that your equipment will
be available for use.
•
Operation: The equipment can only be operated a FTG checking the correct arrangement of the
equipment, instructed in item 3.1, and a FTG following the precautions and recommendations of the
hydraulic installation, electrical connection and gas installation, according to the instructions in items
3.2, 3.3 and 3.4.
Check the following operating instructions:
1. If you have installed a water valve, make sure it is open;
2. Open the gas valves of the cylinders and the gas inlet valve in the oven;
3. Turn the power switch to "1" (on) and wait until the temperature display show the set
temperature;
CAUTION!
The Oven leaves the factory with temperature programmed at 200°C and cooking time 60 minutes. Due
to this programming, as soon as the on / off button is pressed the oven starts the heating and rotation
of the turbine.
To reprogram the cooking temperature and time, follow the instructions below.
4. At this point the turbine and burners will be activated. The rotation direction is counterclockwise,
but only in the FTG300BD model the turbine has double rotation, that is, it rotates 3 minutes
counterclockwise and 3 minutes clockwise automatically without the need for programming.