Bilanciai FLYNET 100, Инструкция по использованию, обслуживанию и монтажу

Страница: 21 / 125

19
FLYNET 100
3.1 Installation
ATTENTION
This indicator must be installed indoors, protected from the weather, as it is not designed to
withstand the elements.
3.1.1 Tabletop installation
Place the indicator on a fixed surface (table or desk without wheels) so that the monitor is not hit by
direct light to avoid reflections, making sure that it is stable and well supported on the non-slip feet.
3.2 Connecting the indicator to the mains
3.2.1 Checks
DANGER
Check that:
•
The power supply line of the indicator has voltage and frequency as indicated on the warning
plate on the power supply unit.
•
The socket to which the indicator is connected is provided with grounding pin.
•
Warning and danger plates are present on the hood of the instrument.
•
If this is not the case, inform the maintenance personnel or our Service Department directly.
The plug of the power cable has an IP20 protection rating, provide a connection to the mains
adequately protected according to environmental conditions.
WARNING
The indicator complies with the European directive on electromagnetic compatibility, however it is
good practice to provide a separate power supply from power drives.
WARNING
Do not place power cables next to the connection cables of the indicator that could cause
disturbance to the operation of the instrument. Use the supplied cable to connect to the indicator.
If the cable is short, do not extend it with joints, but contact the Manufacturer.
DANGER
Insert the plugs and switch the indicator on only after making all the other connections to any
peripheral devices (scale, printer, serial ports, Ethernet, I/O, etc.).