Bilanciai D400, Инструкция по использованию, обслуживанию и монтажу

Страница: 15 / 59

✔
Apply leverage using a screwdriver, for example, at points 1.
✔
Unstick the keypad.
✔
Remove all glue residue with alcohol.
✔
Take care not to get alcohol anywhere other than the contact
surfaces and take care not to damage the seal labels. Allow the
contact surface to dry.
✔
Insert the connector in slot 2 and stick the keypad down, positioning it
carefully in the centre of its housing.
13.8 Replacing the lithium battery
To replace the lithium battery proceed as follows:
✔
switch off the terminal and disconnect the mains lead;
✔
open the terminal as indicated in par. 13.1 on page 3-7 ;
✔
remove the power supplier ( par. 13.3 on page 3-9 );
✔
reconnect the mains lead and switch the terminal on (the battery must
be replaced when the terminal is powered on to prevent loss of data);
✔
remove the battery from the battery holder (point 1 fig. 13.9 on page
3-16 );
DANGER
Take care not to cause short-circuits between the metal
components.
✔
fit a charged battery. Only use a lithium CR2045 battery;
✔
dispose of the old battery in accordance with applicable regulations.
Do not dispose of it improperly.
D400
3-15