BIJUR DELIMON INTERNATIONAL
(919) 465 4448
LOCAL
(800) 631 0168
TOLL-FREE
(919) 465 0516
FAX
WWW.BIJURDELIMON.COM
2100 Gateway Centre Blvd., Suite 109
Morrisville, NC 27560
21836 • R3
05/12
1
TM-5 Lubricator
Automatic Cyclic
Operation
Lubricator is a motor-driven piston pump spring discharge type. Pump cycle time is controlled by an
integral gear reduction in the motor. Lubricator can be actuated manually by raising and releasing
the instant feed button. Available cycle times are shown in the table below.
Cycle Time
50 Hz
60 Hz
6.4 min
5.3 min
10.6 min
8.8 min
32.0 min
27.7 min
64.0 min
53.5 min
128.0 min
107.0 min
Technical Data
Reservoir Capacity
1 liter (approximately 1 quart)
1 gallon
Lubricator Inlet Filter
40 micron particle separation
Discharge Pressure
60 psi maximum
Factory Discharge Setting
5cc
Discharge Volume Per Cycle*
2.5 to 5cc infi nitely adjustable
Viscosity range
150 to 8,000 SSU at operating temperature
Notes Regarding Use
1. Lubricator inlet fi lter should be inspected periodically and cleaned/replaced as required.
2. Discharge pressure will decrease as discharge volume decreases, the number of meter units in
the system increases or oil viscosity decreases.
*Discharge Volume Per Cycle
To reduce oil delivery, remove lock screw, measure “A”, turn adjusting screw clockwise, increasing “A”
by “B” dimension, as shown on table below.
B
Discharge
0.40”
2.5cc
0.32”
3.0cc
0.24”
3.5cc
0.16”
4.0cc
0.08”
4.5cc
0”
5.0cc
!
,OCKSCREW
!DJUSTINGSCREW
Note: Conversion kits for Crouzet motors
are available – request part #26600.
