GUANGDONG ACES MACHINERY CO.,LTD
47
back up the files and remove them
from the computer hard disk.
10
Patterns of knitted fabrics deformed
after printing
After finishing the pretreatment,
select a knitted fabric to detect
shrinkage (the shrinkage of general
knitted fabric is different in warp and
weft directions). Deform the pattern
according to the shrinkage and then
print.
11
Graphs with more than one step in pass
overlap mode have iradjustable white
lines or overlaps between steps
Uncheck “Pass Overlap Mode”and use
scanning step
12
Slight blockage of nozzle or oblique
printing leads to white line
Turn on feathering and adjust the
value to weaken white line defects
Increase Pass to print
13
Unclear dots or double lines on the print Adjust Bi-Direction offset calibration
14
White lines between two heads on
vertical direction
Vertical calibration is out. Need to be
re-calibrated
15
Errors show on the
touchscreen
Equitment
Resetting
It is normal.When starting or resetting
the machine
Left(right)Safetyba
r Hit!
Left(right) Safetybar hits something,
must Emergency Stop immediately,
and get rid of obstacles, in case of
damaging heads!
N.Pre.Cartridge
Full!
Refer to Chapter 4-I-3A-4
X Servo Error
Check
error
code on
the servo
16.0 Over load, head
carriage hit the
limit. Must pull the
carriage to the
middle
of
the
crossbar
and
restarthe machine.
55.0 Reading differ from