Big Joe PTE 30 Series, Эксплуатация, техническое обслуживание, список запасных частей

Страница: 11 / 96

901467 2-5
Figure 2-5. Belly-Button Switch
2-7. STEERING ARM PNEUMATIC SPRING.
The steering arm pneumatic spring automatically
raises the steering arm to the upright position when
the steering arm is released. If the steering arm does
not return fully, the steering arm pneumatic spring
requires replacement. Return truck to maintenance for
repair.
2-8. LIFT AND LOWER CONTROLS.
Lift/Lower Control buttons are located on the steering
control head. (
Figure 2-3 )
To lift forks, push in LIFT button and hold until forks
reach desired height. To lower forks, push in LOWER
button and hold until forks descend to desired height.
2-9. LOADING AND UNLOADING.
1. Move truck to location where load is to be picked
up.
2. Move the truck into position so forks are within
pallet or skid, and the load is centered over the
forks and as far back as possible.
3. Raise forks to lift load.
4. Drive to area where load is to be placed.
5. Move truck to align load with its new position.
6. Lower the load until it rests squarely in place and
the forks are free.
7. Slowly move the truck out from under the load.
2-10.PARKING.
When finished with moving loads, drive truck to its
maintenance or storage area. Push the emergency
disconnect switch in and turn off the key switch.
Charge batteries as necessary. Refer to battery care
instructions,
SECTION 3.
R6455