Big Dutchman Dry Rapid DR 1500, Монтаж и эксплуатация

Страница: 154 / 185

Page 144
Release for volume dispenser
DR 1500
Edition: 08/10 M 4021 GB
5. At open release circuit, lay the release rope around the tension spring at the fork
head and fix it with rope clamps.
Figure 12-19: Fastening of the release rope when it is open
6. We recommend to seal the rubber band with silicone at the adjusting spindle after
the installation of the release system is completed.
12.4 Recommended assembly order
1. Determine the distribution of the release rope and the location for the release
devices (cable winch and winch motor).
2. Attach the idler rollers at the idler corners and the guides for the release rope at the
feed pipe.
3. Position the wire rope in the area of the volume dispensers.
4. Assemble the idler rollers at the same height and alignment as the course of the
release wire at the wall.
5. Fix the release devices to the wall / tube, and for an open release circuit the cup
hook for the tension spring at the wall.
6. Tension the release rope around the idler corners and guide it through the
guidances up to the release devices.
7. Connect the traction ropes of the volume dispensers BR resp. the combed slivers
of the volume dispensers TI with the cable clamps at the release rope.
8. Fix the release rope to the release device.
winch motor
For a better understanding, take a look at figure 12-7 (page page 133) for
release with cable winch or figure 12-10 (page page 137) for automatic
release.