BIG BALE Transtacker, Руководство по эксплуатации и обслуживанию

Страница: 66 / 67

66
9.2.2 Auto Stack Issues
Table 12: Auto-Stack troubleshooting
Symptom Cause
The Turntable r aises but doesn’t extend
forward
•
Check the ‘Minimum Table Lift to
Rotate/Extend’ and compare
to
Turntable lift POT angle in ‘ Sensor
Status ’
•
Bales are pushing against previous layer
already stacked on the platform.
The bales on the turntable get caught in the
extension frame when rotating
•
Decrease the ‘Maximum Table Lift to
Rotate’ setting
The turntable is fully raised and retracted but
the hooks won’t retract
•
Check the ‘Bed Down, Table Retracted
Prox’
, this should be ‘made’ at this
point which would show as a green dot
on the
‘ Sensor Status ’ page
The turntable is raised but won’t retract
•
Check the Turntable Lift POT value,
should be 90 degrees.
•
Bales are stopping the turntable lifting
to 90 degrees or the POT needs
recalibrating
•
Check overall angle tolerance is 2
degrees
The ‘ Auto-Stack ’ cycle cancels when starting
‘ Auto-Pickup ’
•
The joystick is sensitive and needs to be
returned to centre more smoothly
rather than being pushed and released
to avoid cancelling the function
The turntable lowers back down and rotates
but won ’ t lower onto the Stops
•
Check the Turntable Rotate POT on
‘ Sensor Status ’ page
•
Recalibrate the turntable rotate POT
•
Check ‘ Overall Angle Tolerance ’ .
Increase tolerance to 2 degrees
The ‘ Auto-Stack ’ symbol remains highlighted
brown but Turntable is back on the stops
•
Recalibrate the Turntable Lift POT with
the turntable just floating off the stops
•
Increase the ‘ Lower Stack Table
Minimum Speed ’ by 2%
•
Check ‘ Overall Angle Tolerance ’ .
Increase tolerance to 2 degrees
The Transtacker closes up when trailer isn’t full
•
Bed Full switch is on (shows green on
‘ Sensor Status ’ page)
When Turntable is at 90 degrees, the hooks
retract before the Turntable retracts
•
Check the ‘Bed Down, Table Retracted
Prox’
, is ‘made’ at this point which
would show as a green dot on the
‘ Sensor Status ’ page
•
The sensor should be red dot at this
point
When ‘ Extra Layer ’ is ‘ Active ’ and ‘ Auto-Stack ’
finishes with gap between layers 7 and 8
•
Increase ‘ Table Retract Crush Time ’
You find the Turntable pushes the bales too far
out of the rear clamps
•
Decrease ‘ Table Full Continue Time ’