Bien Air Lubricare 2 HIM-2, Инструкция по эксплуатации, Страница: 12 / 52

10
5.2 Operation Panel: Name and Function of Switches and Indicator Lamps
█ Switches
Line Selection Switches Start/Stop Switch
Mode 1 Selection Switch Mode 2 Selection Switch
5.2.1 Recommended Mode
Depending on the type of handpiece, you can choose from two modes. Each mode has different settings for oil
usage and blowing out (idle running) time.
The initial settings for lines 1 to 4 are set for Mode 1. Use the chart below as a reference for changing the set-
tings as necessary.
p. 28 “7.3.5 Switching Maintenance Mode”
* You can select and perform maintenance with Mode 2 for the handpieces recommended for Mode 1, but it may remain excess oil inside the hand-
piece when the maintenance is completed.
Start/Stop Switch
Mode 1 Selection Switch
Press this switch to start or stop cleaning
or lubrication.
Press this switch to select Mode 1 when
connecting handpieces recommended for
Mode 1.
Line Selection Switches
Mode 2 Selection Switch
Select desired line(s) from Line 1 through
4, for handpiece maintenance.
Press this switch to select Mode 2 when
connecting handpieces recommended for
Mode 2.
Handpiece Type
Recommended Mode
Spraynet/Lubrifluid Only for Lubrifluid use
Mode 1
(Operating Time:
20 sec/handpiece)
Mode 1
(Operating Time:
20 sec/handpiece)
Mode 2
(Operating Time:
40 sec/handpiece)
Air Turbine Handpiece
Straight Handpiece
Contra Angle Handpiece: Speed Reduction Model
Contra Angle Handpiece: Constant Speed Model
Contra Angle Handpiece: Speed Increasing Model