Bibby Sterilin Stuart RE300B, Инструкция по эксплуатации

Страница: 4 / 20

2
During use water will be lost from the bath by
evaporation. For maximum efficiency water
should be added periodically and the level
maintained.
Do not fill the bath with any liquid
other than water
Thermostatic cut-out
Should the water bath boil dry or overheat it is
protected by a thermostatic cut-out which will
shut off the heater. When the heater cools the
cut-out will reset automatically.
Should the cut-out operate, isolate the unit from
the electricity supply and allow to cool.
Check that there is sufficient water in the bath
and fill if necessary.
If the cut-out continues to operate consult a
qualified electrician or the Technical Service
Department of Barloworld Scientific Ltd.
Cleaning
Periodically de-scale the water bath using a
domestic kettle descaler suitable for metal kettles.
Follow the instructions for use supplied with the
cleaner.
The water bath should be thoroughly rinsed
before returning to use.
WARNING: Observe any cautionary note on
the cleaner regarding protective clothing and
effluent control.
The exterior of the unit should be cleaned using
damp cloth and a mild detergent solution.
Servicing
Servicing or repair must be undertaken by
suitably qualified personnel.
Only spare parts supplied by Barloworld Scientific
or its agent should be used. Fitting of non-
approved parts may affect the performance of
the safety features of the instrument.
If in doubt, contact the Technical Service
Department of
Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail equipment@barloworld-scientific.com
www.barloworld-scientific.com
Warranty
Barloworld Scientific Ltd warrants this instrument
to be free from defects in material and
workmanship, when used under normal
laboratory conditions, for a period of
three (3)
years. In the event of a justified claim, Barloworld
Scientific Ltd will replace any defective
component or replace the unit free of charge.
This warranty does NOT apply if damage is
caused by fire, accident, misuse, neglect,
incorrect adjustment or repair, damage caused by
installation, adaptation, modification, fitting of
non-approved parts or repair by unauthorized
personnel.