Bibby Sterilin Distinction D4000, Руководство по сборке и эксплуатации

Страница: 3 / 16

3
2. Remove the end cover from the electrical compartment by
undoing the retaining screws in the left hand panel.
3. Take the metal stand and place in the desired location. Note
that 2 screw holes are provided for wall mounting. If wall
mounted the unit should be secured using 38mm (1.5”), No.
10 screws.
4. Take the boiler, the heater and the gasket kit and assemble as
shown in
figure 2 .
i) Place the bolts through the metal flange in the manner
shown and then place the metal flange over the tapered
glass tube of the boiler.
ii) Take the plastic insert and bend it round the glass tube
and into the metal flange. Pull the flange and insert
towards the open end of the glass tube until the insert
presses on the glass.
iii) Place the aluminium plate, followed by the silicone ring
over the heating element and locate approximately 40-
45mm from the end with the electric cable.
iv) Insert the heating element through the tapered glass tube
and into the boiler – ensure that there is clearance at the
inside end and no danger of the end of the element
pressing against the end of the boiler.
v) Now secure the element using the 3 bolts provided. Do
not overtighten.
Location
The Distinction Water Still can be wall or bench mounted. Select a
convenient location which has access to the following services:-
Electricity Supply
Before connection please ensure that the line supply is suitable. The
Distinction Water Still is available in two models, model no. D4000
for supplies rated at 3kW, 220-240V 50/60 Hz single phase and
model no. D4000/EURO for supplies rated at 3kW, 200-230V,
50/60Hz, single phase.
Water Supply
A cold water supply capable of providing a minimum flow rate of
60 l/hr.
Drain
A waste water drain located below the level of the Still so that the
drain pipe can fall away straight without kinks or bends, to allow an
unimpeded flow.
Reservoir
A distillate collection reservoir should be located beneath the Still.
Assembly
1. Unpack the Still and identify the following components:-
Qty. Component Catalogue No.
1 Support Stand D4000/S
1 Boiler D4000/B
1 Condenser D4000/M2
1 Heating element D240H for D4000
D220H for D4000/EURO
1 Hose kit W4000/HK
1 Gasket kit D4000/GK
1 Boiler thermostat tube WTT48
1 Condenser thermostat tube A515414
2 Plastic connecting caps QC18/11
2 Silicone rubber rings QR18/7 and QR18/10
1 P.T.F.E washer QW18/7
1 Reservoir level control WLS
Figure 2 Heater and thermostat tube assembly
Heater
Aluminium
plate
Silicone
ring
Plastic
insert
Metal
flange
Bolts
Boiler
Screwcap
Tapered glass tube
Boiler
thermostat
tube
40-45mm