Page 29
NEDSP1061-KBD Operating Manual
Figure 6. Switch mounting hole details.
Appendix B K
enwood TS50.
14.
Solder the screen from the DSP board to the ground
on CN10 and insulate with tape.
15.
Refit CN10 plug into CN10 socket.
16.
Replace the speaker and speaker mounting bracket
making sure no wires are getting pinched.
17.
Place two thicknesses of double sided tape to the
front right corner of the speaker bracket and mount
switch PCB (see figure 5).
18.
Connect radio to power and aerial and test DSP
board works OK readjust beep, input and output
levels if required. (Details in section 4 page 14)
19.
Drill the top cover as detailed below.
20.
Place the cover on the radio and check alignment
of the switch and adjust if necessary.
21.
Replace the top cover screws and fit the bhi label.
5.1
52.0
25.0
4mm
diameter
3.5mm
diameter
Front
