5
English
FITTING THE BATTERIES.-
This monitor uses one CR2032 3 volt
battery.
To fit the battery, remove the rear
cover on the monitor, Fig.1, and
carefully insert the battery into the
battery compartment (A) making sure
that the battery’s polarity is correct
(matching the battery’s «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign). Close the cover, as
shown in Fig.1.
Important:
Deposit
electronic
components in special containers Fig.2.
ELECTRONIC MONITOR.-
To give you greater control over your
exercise, this electronic unit displays
read-outs of speed/rpm, distance,
exercise time, pulse rate and calories
burnt.
The
screen
will
switch
on
automatically as soon as you start
exercising.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
This monitor has 3 keys: ENTER, UP,
DOWN. The windows at the top of the
display show the TIME; RPM/ SPEED;
DISTANCE;
CALORIES;
PULSE
RATE.
You can reset of all the values back to
zero by holding the ENTER key down
for 3 seconds.
SETUP.-
TIn SCAN mode the computer, shown
in the upper display, continuously
scans and displays all of the functions
every 5 seconds during exercise.
The message line displayed in SCAN
mode:
SPD - Exercise speed
RPM - Revolutions per minute
TM - Exercise time.
DST - Distance travelled
CAL - Kilocalories burned.
PLS - Pulse.
Programming a time limit.-
Once you are in the main screen, you
press the ENTER key the time window
will start flashing. By pressing the
UP/DOWN key you can program a
time limit for the exercise (between 1-
99 minutes). Select the time and press
ENTER to confirm. The time will begin
to count down until it reaches zero and
the monitor will beep several times to
advise you that you have reached the
programmed value.
Programming a distance limit.-
Once you are in the main screen, you
press the ENTER key twice the
distance window will start flashing. By
pressing the UP/DOWN key you can
program a distance for your exercise
(between 1–999 km). Select the
distance and press ENTER to confirm.
The distance will begin to count down
until it reaches zero and the monitor
will beep several times to advise you
that
you
have
reached
the
programmed value.
Содержание H9181
Страница 2: ...2 Fig 1 Fig 2 Fig 3...