BFT PHOBOS N BT, Руководство по установке, Страница: 10 / 12

10
1) SET TO MANUAL OPERATION -
Disengage the drive gear by using the
triangular key and turning clockwise.
2) SET THE CLOSE LIMIT - Push the gate to its fully closed position. Remove the screw
that holds the proximity sensor at the front end of the actuator. Slide it back so that the
back end of the sensor housing is 3-1/2” from the center of the drive carriage and re-
attach screw that secures sensor in place.
3) SET THE OPEN LIMIT - Push the gate to its
fully open position. Remove the screw that
holds the proximity sensor closest to the
actuator body. Slide it forward so that the back
end of the sensor housing is 3-1/2” from the
center of the drive carriage and re-attach screw
that secures sensor in place.
3-1/2”
4) RE-ENGAGE THE MANUAL RELEASE - Use triangular key and turn
counterclockwise to re-engage gears.
SETTING THE LIMITS
5) FINE-TUNING THE LIMITS – Once the actuator is connected to the controller, it
must be powered and the limits might have to be fine-tuned by slidong them to the
correct position.