Chapter 4. Door Station Installation
IP Video Door Station DS06M(P) Installation User Manual
21
Step 15
: using the crimped cable connect the RJ45 socket (ETHERNET) of the door station
controller (
Pic 3.3, 3.4
) straight to a PoE supported router or by means of a PoE injector if the
router does not support PoE (see schemes 2, 3).
If PoE is not used, then connect the RJ45 socket (ETHERNET) of the NC103 controller to a
router using the crimped cable and connect
the «G» and «12V» pins of the controller with an
external DC 12V power source.
To prevent the door station malfunction use only equipment recommended by BEWARD.
4.4. Memory Card Installation
To install/remove a memory card do the following.
Step 1
: remove the 4 screws and open the split-type door station housing. The memory
card slot is located on the upper interface board, on its back side.
Step 2
: take a memory card in a way so that its contacts are facing the interface board and
the slot and insert it in the slot; you should feel/hear a click.
To remove the card from the slot push it to feel/hear a click, the memory card will be
ejected by a spring.
Step 3
: close the split-type door station housing and fix the 4 screws.
ATTENTION!
Switch off the door station before installation/ejection of the memory card. The hot swap of a memory
card is not supported by the door station and may damage the equipment or cause a data loss.