Beverage-Air Williams WBC110, Инструкция по установке и эксплуатации

Страница: 6 / 52

6
The blast cycle is ended under normal operation by:
- Reaching the required temperature 37°F (+3°C).
- Reaching the end of the designated time (90 or 240
minutes).
- Manual cancellation of the cycle by pressing and
holding for 2 seconds.
- Putting the controller into standby mode by pressing
A blast cycle may also be terminated due to the following
faults or failures:
- Over temperature fault.
- HP/LP fault (if enabled).
- Air probe (T1) failure.
- Food probe failure - terminates the blast cycle if all the
food probes fail. If a 3 probe system is used, and 1 probe
fails, the cycle will continue until the last working probe
reaches temperature.
- Main power failure longer than 3 minutes.
Hard or Soft Blast Chill Cycles:
During the hard blast chill cycle the air temperature inside
the cabinet should go down to approximately 14°F (-10°C).
This is for the timed chilling cycle only. Hard blast chill cycles
have the potential to go down to 14°F (-10°C) in temperature.
During soft blast chill cycle the air temperature stays above
32°F (0°C). Soft blast chill cycles have the potential to go
down to 34°F (1°C) in temperature.
DEFROST
A defrost cycle is automatic at the end of each blast chill cycle
to clear any ice from the evaporator ready and to prepare for
the next cycle. During storage mode a defrost will be
performed automatically at the factory preset interval of 6
hours. If a blast cycle is cancelled the machine will
automatically initiate a defrost.
Blast Control Panel
During a defrost the display windows will indicate the
following:
Following a blast chill cycle
An alarm condition is present
- - - will appear in the left window if power
failure happens during defrost mode for a
duration of 3 minutes or greater
A manual defrost can be initiated by pressing and holding
both and
During the defrost cycle all fans will stop running. When the
defrost cycle is finished the compressor will run for
approximately 60 seconds before the fans cut in. It is safe to
leave products in the cabinet during the defrost cycle; the air
temperature rises slightly but will not affect the products
stored.
After every defrost there is a short period; about 5 minutes
during which a blast cycle cannot be programmed. This short
interval is to allow defrost water to drain away from the
evaporator. At the end of each cycle, a defrost will
automatically clear any ice from the evaporator ready for the
next cycle.
ALARMS
When a fault or adverse operational condition arises, an
audible and visual alarm will be initiated:
General alarm in left window / right
window will show mode (storage
temperature / blast or defrost)
Mains failure alarm in left window /
right window will show mode (storage
temperature / defrost; longer than 3
minutes)
The alarm will sound intermittently. Press to mute the
alarm, the alarm will retrigger if the fault causing the alarm
has not been addressed. The alarm mode will still be
displayed.
More information on the alarm can be displayed during
normal operation by accessing the diagnostic menu by
pressing and holding for 3 seconds.
Left window indicates alarm - the
right window indicates the type of
alarm.
90
dF
AL dF
- - -
dF
AL 03
- - - dF
AL E3