BEUMER stretch hood® S
Installation
BA-6090103-EN
19.08.09
33
5 Installation
Safety instructions
Before starting installation, the personnel working in the area where the installa-
tion is carried out has to be informed about the installation work. The whole area
is to be protected against unauthorised access. The barriers have to be provided
with reference plates forbidding unauthorised persons to enter.
Do not permit unauthorised persons to enter! Attach reference plates!
Wear protective clothing when carrying out this work!
Lifting equipment
The lifting equipment is to be selected according to the particular local condi-
tions. The rated load of the lifting equipment must be sufficient.
Warning!
Loads which are incorrectly fastened or components may fall down and
cause serious physical injury or property damage.
Never work or stand under suspended loads! Use only suitable and correctly
functioning lifting equipment and load carrying attachments of sufficient rated
load!
Welding work
If any welding, flame-cutting and separating work is necessary - also on the
building itself - the electric parts have to be protected adequately. If welding,
flame-cutting and separating work is necessary on the machine itself, check
whether there are any installations attached to the reverse side of the surfaces
to be worked on. During welding work, the lenses of the photocells have to be
covered by a protective band in order to avoid burnt spots on the glass. The
temperature occurring during welding must not exceed 55 °C in the area of the
electric parts.
During welding work, the earthing of the welding machine must be
mounted to a component to be welded so that the current can flow well.
Remove paint or other insulating layers from this point.