DISPENSER INSTRUCTIONS
©2009 Betco Corporation
All Rights Reserved.
1001 Brown Avenue
Toledo, Ohio 43607-0127
888-GO BETCO • www.betco.com
Item #91864-92
Rev.2 12/2009
PRE-WORK
CLEANSE
AFTER-CARE
What’s included:
To Change Batteries:
Before replacing batteries, remove bag of
product and pump assembly from dispenser.
1. Use tabs to remove battery cover.
2. Use 4 high-quality C-cell alkaline batteries.
3. Replace battery cover. Close dispenser cover.
Status light on front of dispenser will be green
when batteries are installed properly.
4. Be sure to install bag of product and pump as-
sembly back into the dispenser.
Status Light:
• Green Flash every 4 seconds - Batteries Work-
ing, Unit Working
• Fast Green Flash - Hand/Object obstructing sen-
sor. Remove hand/object to reset dispenser.
• Red Flash every 4 seconds - Batteries Low.
• Red Flash - Unit Failure. Open dispenser cover to
reset unit.
Note:
• Dispenser should be mounted at least 6 inches
above any surface or object.
• If installed above stainless steel or glossy sur-
faces at least a 9” mounting height is recom-
mended.
Foam pump, alcohol towelette, wall anchors
and screws, foam adhesive strips, dispenser
key and 4 C-cell batteries.
