Beta Max MAXIAL TRACK HOIST, Инструкция по эксплуатации и обслуживанию

Страница: 97 / 160

Use and Maintenance Instruction Manual
MAXIAL TRACK HOIST
REV. 2.2 (2017)
MAINTENANCE AND REPAIR
Page | 10-6
Figure 10.1
10.3.1 Ladder track sections
The Ladder Track sections are built of rugged aluminum, so they are strong but lightweight.
Inspection and maintenance of the Ladder Track sections are important to ensure the
structural integrity of the machine.
Perform the maintence described below before use:
—
inspect the rails for any breaks, tears, or deformities
—
inspect that no rungs are bent or deformed
—
inspect the rung welds for any cracks
10.3.2 Sliding Head
Some kind of inspection and maintenance on the Sliding Head should be done daily, refer to
the specifc types of maintenance in the maintence checklists located in this manual.
Perform the maintence described below before use:
—
inspect the frame (1) for any breaks, tears, or deformities
—
inspect the lock bar (2) for any deformities and that the arm moves freely
—
ensure that the lock bar spring (3) is intact and able to function properly
—
inspect the wire rope pulley (4) shows no sign of deformity and moves freely
—
inspect that the wire rope pulley pin (5) shows no signs of damage or excessive wear
DANGER
Inspect every Ladder Track section before every installation. If any of the above
items are found, dispose of that Ladder Track section and do not use. Failure to
inspect the Ladder Track sections can affect the structural integrity of the
machine which could lead to damage of the machine, injury of the operator,
and/or injury to personnel near the machine.