Beta Max MAXIAL TRACK HOIST, Инструкция по эксплуатации и обслуживанию

Страница: 81 / 160

Use and Maintenance Instruction Manual
MAXIAL TRACK HOIST
REV. 2.2 (2017)
SAFETY REGULATIONS
Page | 7-14
7.6.9 Risks arising from handling the machine at the construction site
With the use of lifting equipment, the machine is moved from one area to another, within the
same construction site where it has been installed.
For this operation, the Use and Maintenance Instruction Manual of the machine must be
consulted. Moreover, all necessary measures must be taken to eliminate the risks arising
from the lifting process of the machine.
Possible risks:
— inadequacy of the lifting equipment
— inadequate positioning
Prevention and safety measures:
— always ensure that the lifting equipment used is able to lift the machine within a large
margin of safety
— to handle the machine, always position in order not to damage the machine’s structure
— always check the adequacy of the supporting surface onto which the machine is to be
repositioned and carry out the re-assembly operations of all the service and anchor
structure on the building in question, in accordance with all that stipulated in this
instruction manual
7.6.10 Risks arising from disassembling the machine
The machine’s vertical masts are disassembled together with the relative anchors.
For this operation, the Use and Maintenance Instruction Manual of the machine must be
consulted. Moreover, all necessary measures must be taken for the disassembly of the masts
and anchors.
Possible risks:
— instability of the disassembled components
— instability of the machine
— personnel, material or equipment fall when work is being carried out
Prevention and safety measures:
— pay particular attention when positioning the disassembled components, always
following the indications given in the Instruction Manual, precisely
— disassemble the anchors at the same pace as the Ladder Track components so as not
to cause instability to the machine
— everyone must be prohibited from passing under or stopping below the machine and
the area must be properly enclosed