Beta Max MAXIAL TRACK HOIST, Инструкция по эксплуатации и обслуживанию

Страница: 52 / 160

Use and Maintenance Instruction Manual
MAXIAL TRACK HOIST
REV. 2.2 (2017)
INSTALLATION
Page | 5-3
5.3 INSTALLATION PROCEDURE
Once the ideal location for the Maxial Track Hoist has been determined, the setup and
operation are not complicated. There are no tools necessary for installing your Maxial Track
Hoist. When deciding upon the most suitable position for the hoist, several items are to be
considered. These include whether the unit is to be attached to modular or frame scaffolding,
whether the operating system is centrally located, and whether the scaffold carrier clearances
are satisfied.
1. Using a 9 ft 9 in. (3.0 m) section of track, lay the track flat on the ground.
Notice that the rungs are not centered front to back on the track. Track should be
positioned with rungs closer to ground than to installer.
2. Insert the Base Feet into the bottom of the 9 ft 9 in (3.0m) section of track.
3. Fasten the Base Feet to the track with a Kwik bolt in each foot assembly. When
installing the Kwik Bolt there is no need to remove the wing nut and washer. Push
the Kwik Bolt through and turn 90 degrees. Hold in place and tighten the wing nut.
Figure 5.1
Figure 5.2