DataPro 500 Operator Guide
European Commission Requirements
European Commission Requirements
This equipment is intended for use in a heavy industrial environment. The equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to other equipment. There is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to other equipment the user is encouraged to try to correct the
interference by one or more of the following measures:
- Re-orientate or relocate the equipment.
- Increase the separation between the pieces of equipment.
- Connect the pieces of equipment on separate mains circuits.
- Ensure that the relevant items of equipment are properly and securely earthed to a common earth point using
adequately sized cable or other means of connection.
Where supplied or specified, shielded interconnection cables must be employed with this equipment to ensure
compliance with the pertinent RF limits. Changes or modifications not expressly approved by the company could
void the user’s authority to operate the equipment.
This product has been rigorously tested to comply with the European EMC (Electromagnetic Compatibility) Directive.
With regard to this, Beta LaserMike recommends that any non-Beta LaserMike peripheral equipment is CE marked
for the Heavy Industrial environment (EN50082-2). Beta LaserMike also recommends that any cables not supplied
by Beta LaserMike, but used for powering Beta LaserMike equipment, be built using good EMC practices (i.e. cables
with braided shield, and connectors with 360
°
termination of the braid to a metal/metalised shell connector at both
ends). If you have any questions regarding this, contact the Beta LaserMike Service Department.
Part No. MAN/EN5400-0001
Page 4 of 14
Revision B (Jun 2010)