Bestway 53302E, Руководство пользователя

Страница: 3 / 40

3
303021219478_53350/E_53344/E_53346/E_53348/E_53352/E_14x21cm
• Do not draw and pull motor leads, and do not bump the air blower, you’d better use the air blower between negative five and fifty
centigrade, If you let the air blower be baked in the high temperature, motor leads enamelled cables and heating bodies will aging and
shorten it’s life.
CAUTION - ELECTRICALLY OPERATED
PRODUCT:
NOT RECOMMENDED FOR CHILDREN UNDER14 YEARS OF AGE.
AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE
OBSERVED DURING HANDLING AND USE TO PREVENT ELECTRIC
SHOCK.
KEEP CHILDREN AWAY: Do not allow children to play with or around the unit, in any way, which could result in injury.
PROTECT POWER CORD FROM DAMAGE: Never operate a unit with a damaged power cord, as this may lead to electrical or
fire hazards. If the power supply cord is damaged, it must be replaced by a cord of the same type and amperage rating.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
• Warning: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
OPERATION
Place the air blower on a steady net surface where children can be kept away. This air blower is for use on a nominal 120-volt
circuit and has a grounding plug similar to the plug illustrated in sketch (A). Only connect the product to an outlet having the same
configuration as the plug.Do not use an adapter with this product.
ON/OFF SWITCH
OFF — O
ON — l
GROUNDING METHODS
Grounding Pin
Sketch A
Grounded
Outlet
Keep Unit Grounded: air blower should be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for the electric current.
This product is equipped with a cord having a grounding wire with an appropriate grounding plug.
The plug must be plugged into an outlet that is properly installed and grounded in accordance with
all local codes and ordinances.
Warning:
Improper installation of the grounding plug is able to result in a risk of electric shock.
When repair or replacement of the cord or plug is required, do not connect the grounding wire to
either flat blade terminal.
The wire with insulation having an outer surface that is green with or without yellow stripes is the
grounding wire.
CAUTION: Check with a qualified electrician or serviceman when the grounding instructions are
not completely understood, or when in doubt as to whether the air blower is properly grounded. Do
not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified
electrician. The appliance must be positioned so that the plug is accessible. If the supply cord
is damaged, it must be replaced by the manufacture or its service agent or a similarly qualified
person in order to avoid a hazard.