Sport Bar Covers - Installation Instructions
Rev. B 1106
80022 / 80023 pg. 2
Parts List
Sport Bar Cover Qty - 1
Horizontal Sport Bar Covers Qty - 2
Use the #30 Torx to remove the bolts on the speaker pods.
Pull the pods out slightly to expose the wiring inside. Release
these wires by lifting up the tab on the connector. The speaker
pods can be removed and set aside for later.
Remove #30 Torx Bolts
If your vehicle has sport bar
covers, you must cut them
off before beginning this
installation. The casing
around the front seat belts
can be pulled out slightly to
remove the fabric under it.
If your vehicle has a soft top,
release the top
from the windshield and lay the top and bows
down on the tailgate.
Use a T-30 Torx driver to remove the Pivot
Knuckle Screws that attach the Side Bow and
Rear Bows to the brackets on each side of the
vehicle. Push down on each bow to pop it loose
from the bracket.
Leave the bows and fabric laying on the tailgate.
Driver's Side Shown
Side Bow
Pivot Knuckle
Rear Bow
Pivot Knuckle
Remove Pivot
Knuckle Screws
Front
The installation of the Sport Bar Covers will be
easier if the door molding is removed. To remove
the door molding, unscrew the knobs above the
door opening and lift the molding off of the vehicle.
Door Molding
Knobs
Lower Soft Top
Remove Speaker Pods
Tab
Connector
Pod
Remove Existing
Sport Bar Covers
Front seat
belt casing
Remove Door Molding
