background image

BEST ACCESS SYSTEMS

Indianapolis, Indiana

For factory prepared doors only

Caution:  

If you use hollow metal doors, determine whether the 

doors are reinforced enough to support the lock. If door rein-
forcement is not adequate, consult the door manufacturer for 
information on proper reinforcement.

Simplified instructions

1  Install the latch so that the bevel on the latchbolt faces the strike.
2  Adjust the outside rose assembly so that the chassis is centered in 

the door. Install the chassis from the outside of the door.

3  Install the inside liner, through-bolts, rose, lever, and strike.

For field door preparation and detailed installation instructions, see the 
following steps.

1

Position template

1  Fold the template and place in position on the high edge of the door 

bevel (see Figure 2).

2  Mark the drill points for lock and latch.

Note: 

The suggested height from floor to centerline of the lock is 

40

5/16

. If steel frames are used, the latch centerline must be in line 

with the center of the strike preparation.

2

Bore two holes and install latch

1  Bore a 2 1/8

 diameter hole from both sides of the door, to the center 

of the door as shown in Figure 3.

2 Drill 

1

 diameter hole from the edge of the door that intersects the 

2 1/8

 hole.

3  Mortise the door edge for the latch face.
4  Install the latch and check the door swing. Latch tabs should project 

into the 2 1/8

 diameter hole.

3

Remove inside knob and 
rose & liner assembly

1  Insert the spanner wrench tip into the knob keeper hole and depress 

the keeper.

2  Slide the knob off.
3  Remove the rose and liner assembly.

 Figure 1 — Overview diagram

 Figure 2 — Positioning the template

Inside rose

Inside liner

Latch

Through-bolts

Outside rose

Bevel on 
latchbolt

TEMPLATE

 

High edge of door bevel

 Figure 3 — Boring two holes and installing the latch

 Figure 4 — Removing the inside knob and rose & liner assembly

2 1/8

 dia. hole

1

 dia. hole

Latch

Knob keeper hole

Rose and liner 
assembly

T56061/Rev A    1797989   ER-7991-19    May 2003

Installation Instructions 
for 62K–65K Cylindrical Locks 

Отзывы: