– Safety for your child!
Please observe
these user instructions …
BeSafe 1-2-3 is suitable for all vehicles with lap/shoulder seat belts permitted under ECE Standard 18 or similar.
Vehicles list:
Alfa Romeo, Audi, Austin, BLMC, BMW, Buick, Cadillac, Chevrolet, Chrysler, Citroën, DAF, Daihatsu, Dodge, Fiat, Ford, GM, Honda, Hyundai, Jaguar,
Lada, Lancia, Mazda, Mercedes, Mitsubishi, Nissan, Oldsmobile, Opel, Peugeot, Plymouth, Pontiac, Porsche, Renault, Rover, Saab, Seat, Skoda,
Subaru, Suzuki, Talbot, Toyota, Volvo, VW.
GB
Instructions
BeSafe 1-2-3 can only be used with the vehicle’s 3-point seat belt.
1.
Push the shoulder and head supports and back support as far as
possible into the seat upholstery.
2.
Seat the child and insert the 3-point belt lock into the lock. The
shoulder belt must run between the head and shoulder supports.
3.
The lap belt must run over the child’s pelvis.
4.
The cross-section of the seat cushion forms a guide for the lap belt.
The shoulder belt must also pass through the lap belt guide at the
point where it touches the seat.
5.
The shoulder belt must now be fixed with the fixing clamp (Fig. 2).
6.
When doing so, tighten the 3-point belt so that it fits snugly over the
child without being uncomfortable.
7.
As the child grows, adjust the head-shoulder supports and back
supports to fit the child’s upper body.
8.
Make sure the belt does not get twisted in use.
·
Do not continue to use the child seat after an accident.
·
Make no changes or other alterations to the child seat.
Fixing clamp
✔
The fixing clamp (Fig. 2) must be used to secure the shoul-
der belt. This prevents the child pulling the loose belt out of
the belt roller.
✔
Fix the fixing clamp to the shoulder belt at the side of the seat
between the shoulder and the head support.
✔
Tighten the seat belt as firmly as possible, without causing
the child discomfort.
✔
When the fixing clamp is used, the seat belt will always be
available in the correct length
We recommend:
Allow plenty of time with the child before starting to use the
child seat. The child needs to become familiar with the seat
and seat belt. To encourage use of the seat, explain to the
child that it is important for road safety. In vehicles with airbag
on the front passenger seat, children under 12 should not sit
in the front.
Group 2 15–25 kg
Group 3 22–36 kg
Fitting instructions
Remove the screw from the seat cushion.
Place the seat cushion on the steel tubu-
lar frame.
Rotate the screw through the fitting into
the thread on the seat cushion
Tighten well (Fig. 3)
Read the instructions carefully
Fig. 1
Fig. 2
Belt lock
Producer:
HTS BeSafe as - N-3535 Krøderen
www.hts.no
ECE R44-03
03150
15-36 kg
Fig. 3
Please note:
1. This is a “universal” child seat. It is permitted under the regulations of ECE Standard 44 03 for
general use in vehicles. It is suitable for most but not all cars.
2. If the car manufacturer states in the vehicle instructions that the seats in the car are suitable for
a “universal” child seat for the appropriate age range, correct installation is assured.
3. This child seat was tested to stricter criteria than models which are not classified as “universal”
child seats.
4. In case of doubt please consult your specialist dealer.
