H D P R O L E D
ANNEE FABRICATION 2016
Note of use of range BERSUB:
www.bersub.com
DIVE LIGHTS
Congratulations
, you have chosen a high-quality BERSUB divelight. In order to obtain maximum satisfaction, please read the
following instructions carefully before use.
Warning : Before using the divelight for the first time, it must be charged fully.
1 - Charging -
1-1- Do not discharge the battery pack before charge it.
1-2- Make sure that the divelight and the charging pins are dry and the switch lever is turned "Off".
1-3- Allow the divelight to cool down a few moments after it has been used before charging it.
1-4-The
standard charger
allows you to charge the batteries using a 220V AC 50 Hz source. Power consumption: 15 VA maximum.
Charging time: about 12 hours
Plug the charger's double-pole plug onto the divelight’s pins socket, and line up the white mark with the white dot
.
If you have partially used the divelight, you can top it off with the charge that is necessary.
The charger does not shut off automatically, so charging time must be monitored. The "LED" provides information about the "charge
in progress". If you allow the charge to continue a little longer, this does not cause any problems as long as you do not do this too
often. There is a safety feature that will automatically cut off the charge if the temperature of the batteries exceeds the
recommended value.
1-5- The
automatic battery charger
(5920030D5) performs an accelerated charge using constant current then automatically switches
over to a trickle charge (which does no harm to the batteries over a long period) once the batteries have been charged.
This charger allows you to charge the batteries using a 100/240V, 50/60Hz source). Power consumption: 25 VA maximum. (Other
internationals plugs are availables on demand)
You can charge your divelight regardless the state of charge of the battery pack.
- CONNECT THE CHARGER TO THE SECTOR :
The green LED switch on: power on
- CONNECT THE DIVELIGHT TO THE CHARGER :
(white mark line up with the white dot) the LED become orange: indicates fast
charge in progress. The divelight is full of charge when the LED passes by again the green. The charger will rock then
automatically on the load of maintenance without limit of time.
The charger cannot rock in load if:
- the switch is “on”, safety not locked.
- the battery pack is hot
- the connectors are oxidized
- dysfunction of the divelight
Time of charge: 4 hours
1-6- Ni-Mh batteries, when they are not being used, lose more than 1% of their residual charge per day, so after one month, hardly
70% of the charge will be retained.
Recommendation:
