January 2021 © Yeiser Research & Development LLC and Bernini Fountains®
Trade names, product names and logos
used in this document are the trademarks or registered trademarks of Yeiser Research & Development LLC, Santee, CA 92071
Table Guard Fly Fan
TM
Instructions
ASSEMBLY:
Figure 2
Figure 3
-
Figure 4
Figure 5
Figure 6
Figure 7
Figure 1
Battery Installation:
Step 1: Remove the Table Guard Fly Fan
TM
from the packaging (Figure 1).
Step 2: Open the Battery Compartment Door (Figure 2 A ). The Battery Compartment Door swings open (Figure 3 A ).
Step 3: Insert 2 AA Batteries into Battery Compartment (Figure 3 B ) (Batteries not included, for best results use fresh batteries).
Step 4: Close the Battery Compartment Door (Figure 4 A ). The Battery Compartment Door has 2 clips that fit into 2 corresponding square holes. Swing and snap closed (Figure 5 A ).
Step 5: If you wish to hang the Table Guard Fly Fan
TM
from the ceiling, a built in hook on the base of the fan (Figure 7 A ) allows it to hang upside down, and a notch in the hook
ensures it will hang straight.
Please Note:
1. Do not mix old and new batteries.
2.
Do not mix alkaline, standard (Carbon-zinc),
or rechargeable (Ni-Cd, Ni-Mh, etc) batteries.
