Berner BHWKTD3.5, Руководство пользователя, Страница: 24 / 44

Page 23 Of 44 17.07.2014
Ver. 3.6 © Bernese cooking systems 2018
During operation, the pot detection is carried out by the recorded power.
The sensitivity can be adjusted by means of a DIP switch, so that even small cookware is detected.
If an unsuitable cookware (e.B. aluminum pot) is placed, the error message "F" appears.
External display
Startup
Display Time Declaration
1st second Testing the segments
2nd second Operating mode Pulse
3rd second Software version 1st digit
4th second Software version 2nd digit
5th second Software version 3rd digit
Normal operation
Display Importance Declaration
Residual heat
indicator
PT1000 Hob Temperature > 45°C
Pot detection
induction switched on but no pot is put on.
Decimal point lights up with pot detection every second
after 1 min every 5 seconds
Operation
Power display 1-9 and decimal point continuous lights:
Performance is surrendered
Reduction 1 Decimal point flash1s: KK temperature limit
Reduction 2 Decimal point flash500ms: coil temperature limit
Reduction 3 Decimal point flashing 200ms: Power limit
Reduction 4
Decimal point flash100ms: HF peak limit (not optimal
pan material)
Pot rating
The pot evaluation determines how well a cookware is suitable for the
induction system.
Poor cookware, leads to excessive heating of the electronics and to performance limitation. Poor
efficiency and limited power control
are further significant disadvantages.
To display the pot rating, the induction must be set to maximum performance.
The evaluation varies depending on the connected peripheral.
Pot rating does not work Smart Power Dual operation.
Pot rating light with 1 display
Set to full power and observe flashing point at the 7-segment display at the bottom right.
reduce power until the point is permanently lit.
The performance level, which is then displayed, corresponds to the pot rating
The larger the number, the better the cookware (values of 1-9).