Bernard T-Gun 445-45, Руководство пользователя

Страница: 23 / 30

7-5 Changing Cable Assembly
1. Remove nozzle, contact tip and retainer.
2. Take out rear housing screws and pull out liner.
3. Pull the rear handle up the gun approximately 1 foot.
4. Unscrew power cable from rear power block.
5. Cut clamps off the water-in (blue) line and gas (white) line.
6. Pull gas and water line off of power block. At this point, rear
power block will be removed from gun.
7. Slide rear handle off gun.
8. On front of gun, release front handle from neck.
9. Remove outer jacket by pulling outer jacket only from rear of
gun. All that remains are the inner hoses attached to the neck
and switch lead wires.
10. Unthread power cable from front of gun and replace with new
one.
Figure 7-H
Figure 7-I
Figure 7-J
Figure 7-K
TG408-1.2 19