Irrigation
IOM
Sensors
| 51 |
9 TROUBLESHOOTING
For the TROUBLESHOOTING section (Problems / Causes / Solutions), please refer to the instruction manual of the
converter associated with the specific sensor.
10 CERTIFICATIONS AND TECHNICAL FEATURES
Please refer to the sensor and converter catalogs to see the list of the certifications and all the technical features
related to your product.
11 SENDING THE FLOWMETER TO THE MANUFACTURER
The device was manufactured with extreme care and passed rigorous tests before shipment from the factory.
If the installation and maintenance are carried out correctly, it is very unlikely that malfunction will occur.
However, if it should be necessary to send the device to our customer service for any checks or repairs, please
pay attention to the following points:
According to the legal provisions on environmental protection and securing the health and safety of our
personnel, the manufacturer can only test and repair those devices returned to us that have been in contact
with products that are risk-free for personnel and environment.
This means that the manufacturer can perform the service on the device only if this is accompanied by the
“repair request form,” stating that the device itself can be safely handled.
12 PRODUCT DISPOSAL
Disposal of the device no longer in use is the responsibility of the user, who must comply with the specific laws
enforced in the country of installation regarding environmental protection.
MANUFACTURER’S STATEMENT
The manufacturer declares that the design, development, and construction of the CONVERTER have been carried
out in compliance with the directive on the reduction of the use of dangerous substances with particular attention
to waste electrical and electronic equipment (WEEE) supporting, from an environmental point of view and the
protection of the health of the worker, the intervention of the subjects who participate in the installation, use,
and disposal of their products (manufacturer, distributors, consumers, operators involved in WEEE treatment).
The crossed-out wheelie bin symbol (Fig. 92) contained on the equipment indicates that the
product must be collected separately from other waste at the end of its useful life.
Therefore, the user must give the equipment at the end of its life to the appropriate waste
collection centers for waste electrical and electronic equipment, or return it to the retailer when
purchasing a new equivalent type of equipment on a one-for-one basis.
Appropriate sorted waste collection for the next start-up of the disused equipment for recycling,
treatment, and environmentally compatible disposal contributes to avoiding possible negative
effects on the environment and favors the reuse and/or recycling of the materials of construction.
Unauthorized disposal of the product by the user results in the application of the administrative
sanctions provided for by applicable law
Fig. 93
The information contained herein may be changed by BERMAD without notice. BERMAD shall not be held liable for any errors.
© Copyright 2011-2021 BERMAD CS Ltd.
F e b u a r y 2 0 2 1