berlinger SmartMonitor SHIP L, Руководство пользователя

Страница: 10 / 75

2.2. Device handling warnings
Air Pressure • Excess pressure or vacuum can damage the device.
Attention
• The SmartMonitor measures the ambient temperature and not the quality of the
monitored goods. Its purpose is to signal if product quality evaluation is
required.
Automatic
flight mode
• Automatic flight mode may not be activated in all aircraft types. Enable manual
flight mode in case of doubt and/or regulation prescribes that radio must be
suspended.
Battery
• The battery cannot be removed or replaced. Check the technical specification
for detailed battery information. Contact the Berlinger support at
support@berlinger.com for refurbishment options.
• Risk of fire or explosion if the battery is replaced by an incorrect type.
• Risk of explosion if the battery is disposed of in a fire or hot oven.
• Leaving the battery in an extremely high temperature surrounding environment
can result in an explosion or leakage.
• Do not subject battery to extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas.
• Instructions required by IEC 62368-1 regarding coin cells.
Compatibility
• SmartMonitor device only works in combination with the SmartView software
(version 6.0 or higher).
Connectivity
• Real-time availability of measurements may depend on local connectivity and
may be delayed.
Damage
• If the SmartMonitor device is damaged, don’t use it and contact Berlinger
support for refurbishment options.
General
• Ensure that the user manual instructions are followed before using the
SmartMonitor for monitoring. Without proper starting, the measurements will not
be available.
Humidity and
pressure
sensor
• The SmartMonitor has built-in humidity and atmospheric pressure sensors. The
sensors are located on the left side of the device and are covered by white
membrane/seal. Keep the membrane clean. Do not push, press, peel-off or pin
the white membrane as it will damage the sensors and affect the water
tightness.
Ingress
Protection
• IP65: Protect from dust ingress and water spray from any direction.
Important: As the configuration can be changed in SmartView while the SmartMonitor
device is running and may not yet have been delivered to the device, the tick and the
cross on the device are indicative and may be revised when the configuration arrives
at the SmartMonitor.
!
Berlinger & Co. AG User Manual SmartMonitor - 1_en
Page 7 of 72